设备概述/
Summary of the equipment
斜管(板旗淀器,是根据平流式沉淀池去除分数性颗粒的沉淀原理制作而成,通过在池内增加斜管,减少水力半径的同时,加 大水池过水断面的四周,因此水流在相同水平流速V时,可以极大的降低雷诺数Re,从而减少蓄流,促进沉淀。另外,加 设斜板还可以使颗粒沉淀距离缩短,减少沉淀时间,提高沉淀效率。
斜管(板)沉淀器是在泥渣悬浮层上层安装倾角60度的斜管组建,使原水中的悬浮物、固体物或经投加混凝剂后形成的 絮体矶花,在斜板底侧表面积聚成薄泥层,依靠重力作用滑向泥渣悬浮层,继而沉入集泥斗,由排泥管排入污泥池另行处 理或综合利用,上清液逐渐上升至集水管逐渐排岀、可直接排放或回用。
Inclined tube (sheet), precipitator is based on the advection sedimentation tank to remove fraction particles produced by precipitation principle, by increasing inclined tube in the pool, to reduce hydraulic radius at the same time, the increase in the cross section of the pool water around, so the water flow in the same horizontal velocity V, can greatly reduce the Reynolds number Re, thus reducing the storage flow, promote the precipitation. In addition, the addition of inclined plate can reduce the distance of particle precipitation, reduce the precipitation time, and improve the precipitation efficiency.
Inclined tube (plate) precipitator is in sludge suspension layer inclined tube to form the upper installation Angle of 60 degrees, the suspended matter in raw water, solid, or after dosing coagulant flocs formed by alum flowers, builds up in the bottom of the ramp side surface thin mud, rely on gravity sliding into a sludge suspension layer, then sank into the collection bucket by exhaust pipe into the further processing and comprehensive utilization of sludge pool, supernatant fluid gradually rose to set the pipe out gradually, can directly discharge or reuse.
Characteristics of the equipment
结构简单、无易损件、经久耐用、减少维修。 占地省、投资少、运行稳定、容易操作。
停留时间短,沉淀效率高,动力少、节约能源。
型号 | 处理 M (m3/h) | 主体外形尺寸(mm) | 工作压力(Mpa) | 工作温度(笆) | 设备形式 |
BXG-50 | 50-75 | 4500x1900 x 3600 | |||
BXG-100 | 100-125 | 5500x1900x4650 | 常压 | rn/nn | 直力式 |
BXG-150 | 150-180 | 6500x2250x4650 | |||
BXG-200 | 185-220 | 7200x2500x4950 |
管理员
该内容暂无评论